Quick Drying Enamel - K-4001

Technical Data Sheet

K-4001 is Quick drying enamel based on specially formulated chain stopped alkyd resin. It gives very hard, tough and high glossy film. K-4001 is used in various applications where very fast air drying properties is required.

Uses :
  • » Automotive Finishes & Refinishes
  • » Heavy Structures
  • » Agricultural Implements
  • » Infrastructure Industries
Product Specification :
PRODUCT SPECIFICATION Specification
Colour Selected Range STEEL SURFACES: Degrease and blast clean or manual cleaning and remove loose rust. Surface should be perfectly clean and dry before applying K – 3001 Zinc Phosphate Primers.

Method of application:

Conventional spray / Airless spray/Brush /Roller for touching up small areas only.

Thinner……………….: QD Thinner - 401
Thinner Intake……… :15 – 20% by Volume
Finish Matt to Glossy
Flash Point Above 25º C
VOLUME SOLIDS 40% Approx.
DFT 25 – 30 Microns
THEORETICAL SPREADING RATE 10 – 12 Sq.meter per litre
DRYING TIME S.D. 5 – 30 minutes
  H.D. 4 – 6 Hrs
  FULL CURE – 72 Hrs
OVER COATING INTERVAL 12 Hrs Minimum
STORAGE LIFE 12 Months in sealed container
Under standard conditions

Data given above are based on laboratory tests; the suitability of the product has to be tested in each case. KPPL retains the right to change the qualifications at any time without any announcement and notification. It is the user's responsibility to conduct all necessary tests to confirm the suitability of anyproduct or system for their intended use. No guarantee of result is extended since conditions of use are beyond our control.